i set the board to Generic STM32F103 series, set upload method : serial, and set the COM Portġ5. i opened Arduino IDE, open blink LED sketch from examplesġ4.
Stm32 driver download serial#
windows recognized the device as Maple Serial (COMxx)ġ2. ran install_drivers.bat in folder drivers, succeeded.ġ1.
if i unplug and replug the USB cable, the LED on PC13 was blinking fast and then blinking slow, and then OFF (as expected)ġ0.
flashed the bin file using command line stlink (i think that using STLINK, it doesnt care if the BOOT0 jumper set to 0 or to 1) and succeeded.ĩ. turned on the bluepill using USB cable which was connected to my laptopĨ.
Stm32 driver download download#
download Roger Clark's Arduino_STM32-master, copied and unzipped it to Documents\Arduino\hardwareħ. i bought 4 bluepill board (china), and changed the 10K resistor to 1K5 resistorĤ. Hello there.i am quite new with bluepill STM32F103 board.ġ. While someone that knows something is reading this, with the generic bootloader named "generic_boot20_pc13" What is the boot20 indicating? I assume where it is jumping to in flash to start execution of the program. Most of the documents I find on the Web use this as an example. I started working on pulling stuff together to use an FTDI device and the UART to load the bootloader. So I feel like the boot loader is in there okay and working as expected.Īll bootloaders have been installed using an ST-LINK2. It does do the super fast blink on powerup and then a slightly slower flash after about 500ms. The last bootloader loaded is labeled generic_boot20_pc13. But I've tried to work through this using a Blue Pill as well. This includes the Maple bootloader and The board is one of my own designs. I have tried several bootloaders actually.
0 kommentar(er)
